20% OFF SITE-WIDE EXTENDED CYBER MONDAY PROMO CODE: "TLBF22"

Plasms Cutter Gen 2 - Part 13: Z Axis Stiffening

by Joey Sacco on January 30, 2016

Alright, I solved my flexing issue by adding an extra plane of support. I drew up these support plates from 14ga steel and sandwiched it between my spacers, 1 inch off the main aluminum plate. I extended my X axis gear reduction bolts through to the front of the plate to mount to the support plates. Again, please excuse the use of nuts and washers as spacers. Once it is all sorted out, I hope to have all proper spacers installed. Here are the plates:

Here they are installed:

LEAVE A COMMENT

Please note, comments must be approved before they are published


BACK TO TOP